Home > News > Industry News

How to solve the problem of the injection molding machine


The cause of machine failure is often caused by improper operation and setting. Simple troubleshooting can be made through analysis.

Adjustment steps of mold locking force and low voltage protection of (the injection molding machine)
1. (injection molding machine)Mold locking high pressure setting: 135bar, 10%; The low-pressure speed setting is 20%, and the low-pressure position setting value is 100mm; The low pressure time is set to 5 seconds.

2. (injection molding machine)Use the advance and retreat of mold adjustment to establish the mold locking force; The maximum rising value of the system pressure gauge when the mold is closed at high pressure shall prevail. Refer to the mold locking force oil pressure comparison table.
We use cookies to offer you a better browsing experience, analyze site traffic and personalize content. By using this site, you agree to our use of cookies. Privacy Policy
Reject Accept