The solution of the injection molding machine fault
2022-01-28
3. （injection molding machine)Set the low pressure position to zero after mold opening.
4. (injection molding machine)Press to close the mold until the mold contacts and release it immediately. At this time, assuming that the moving mold position is "X", the low pressure position is set to "x + 1" mm.
5. Then set the low-voltage protection width: the low-voltage protection width is the distance from low speed to low voltage.
6. Set the low-voltage protection time to 1.2 seconds
4. (injection molding machine)Press to close the mold until the mold contacts and release it immediately. At this time, assuming that the moving mold position is "X", the low pressure position is set to "x + 1" mm.
5. Then set the low-voltage protection width: the low-voltage protection width is the distance from low speed to low voltage.
6. Set the low-voltage protection time to 1.2 seconds
